Connection To An Operator Backend System; Introduction - Siemens VersiCharge 8EM1310 Series Connectivity Manual

Connection to an operator backend system

7.1

Introduction

The OCPP parameters are set via the Siemens Device Management. The data stored there is
then transferred to the successfully connected and registered charging station.
7.2 Integration tests with the backend operator
It is only possible to connect the VersiCharge with operator backends that have already
successfully passed integration tests. This is the only way to ensure that connection to the
backend system works correctly. In this integration test, the necessary parameters (such as
OCPP endpoint) are stored in the Siemens Device Management.
Please contact your Siemens contact partner in relation to this.
7.3 Assigning VersiCharge to the backend operator
After successful integration tests and successful registration of the VersiCharge in the
Siemens Device Management, the serial number of the VersiCharge must be assigned to the
certified operator backend.
Please contact your Siemens contact partner in relation to this.
The options offered by VersiCharge connected to an operator backend depend on the
backend provider. The VersiCharge complies with the OCPP standard.
7.4 Optional: Replacing the SIM card:
It is possible to replace the SIM card of the VersiCharge. Information on how this works can
be found in the enclosed operating instructions. When a non-Siemens SIM card is used, the
connection for the Siemens Device Management must be made available so that service and
remote updates of the firmware can be enabled.
Use of the provider's own SIM card with VPN is not intended, because no connection to the
Siemens Device Management can be established in this case.
VersiCharge Connectivity Guide
Getting Started, 12/2021, A5E51237456-AA
7
29