Starting And Driving (Peps) - TATA Motors TIGOR EV 2021 Owner's Manual

WARNING
• Always make sure to keep the gear
shift knob in the 'N' position ignition
is ON and vehicle is stationary.
• Do not shift the rotary knob in 'N'
position, even momentarily, when
the vehicle is in motion.
Reverse
Reverse gear can be engaged only when
vehicle is stationary and brake pedal
pressed. An audio signal indicates when
reverse gear is engaged. 'R'
cated in instrument cluster.

STARTING AND DRIVING (PEPS)

Motor Passive Start / Stop
will be indi-
Start/Stop button is provided on the dash-
board towards the left side of steering
wheel.
Start / Stop Button
A Start/Stop button or Push to Start Button
is a main component of Passive (Motor)
Start and Stop system. It is used to control
ACC, IGN outputs as well as to start and
stop the motor.
STARTING AND DRIVING
NOTE
• If Smart key is inside the vehicle
and on pressing start stop switch, if
start stop switch green LED blink for
10 seconds then rotate steering
wheel and simultaneously press
start/stop button again.
• If smart key is inside the vehicle and
on pressing start stop switch, if
start/stop button green LED blinks
more than 10 seconds, then contact
authorized TATA MOTORS EV
dealer.
• If ESCL (Electronic Column Steer-
ing Lock) is not unlocked properly,
then vehicle doesn't go into ACC
mode.
Backup Start
If smart key battery voltage is low or empty
and vehicle is in OFF mode then to start
the motor user needs to press start/stop
button two times with interval of 2.5 sec-
onds between two presses after pressing
the brake pedal with valid smart key near
145