Table of Contents
Advertisement
Chapter 2
Installing the Subscriber Unit
1
Figure 13:
1. Loading Bar 2. Wires 3. Pin 1 4. Pin 8
8.
Trim the wires until they are flush with the face of the loading bar.
9.
Insert the wires and loading bar into the plug body. Make sure:
• the cable is pushed to the front of the plug body
• the spine of the strain relief on the plug body covers the drain wire
10. Bend the strain relief until it is flat against the jacket and foil.
11. Crimp the plug and strain relief using a standard crimping tool.
12. Trim away any excess foil or drain wire extruding from the strain relief.
13. Slide the connector components up to the plug body.
14. Insert the modular plug into the plug housing.
Figure 14: Assembling the Connector Components
1. PoE Plug 2. Plug Housing 3. Dust Cover
15. Align the latch with the LATCH slot.
16. Press the plug into the plug housing until it bottoms out.
17. While maintaining inward pressure on the plug or keeping the dust cover engaged, tighten the compression
nut to 0.56 N·m (5 In-lbs).
18
8
6 7
4 5
2 3
1
2
2
1
1
3
1
2
3
RUGGEDCOM WIN5251
Installation Guide
1
7
5
8
3
6
4
2
4
Assembling the PoE Connector
Advertisement
Table of Contents
