Table of Contents
Advertisement
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier
Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier
NOTE: Installation is to be completed by a qualified electrical technician according to
NEC/CEC code and applicable local codes.
Installation Instructions for
The AMP-BT2SIC5 / AMP-BT2SIC6 carton includes:
1. One (1) each AMP-BT2SIC5 / AMP-BT2SIC6 (In-ceiling 2 Source Amplified
Speaker)
2. One (1) each UL Listed, Level 5
3. Four (4) each Mounting screws
4. One (1) each cardboard mounting template
5. One (1) each User Manual
The AMP-BT2SIC5 / AMP-BT2SIC6 Combination carton includes items 1 to 5 above plus the
following:
1. UL Listed 8 ohms in-ceiling speaker model IC5 / IC6
2. UL Listed Backcan Enclosure (See Pages 15 & 16)
3. UL Listed Tile Bridge (See Pages 15 & 16)
*Note: Quantity of Ceiling speakers, tile bridge and backcan depends on the SKU of the
AMP-BT2SIC5 / AMP-BT2SIC6 Combination Program.
Speaker Placement
Before installing your OWI speakers, consider the placement carefully, taking into effect the
location of electrical, plumbing and other fixtures.
Placement in Ceiling
OWI speakers should be located above the primary listening area.
Mounting your OWI speakers
Determine the best area to mount your OWI speakers. It will be necessary to run your speaker
wires to that location. This location must be free of obstructions, such as electrical conduits,
HVAC ducts, or water lines.
Be sure the mounting surface is between 3/8 and 1 ¼ inches thick and that there is at least a
3
inch clearance behind the mounting surface (5 inch if using an OWI backcan). Make sure
that no objects block the back of the speaker.
Remove the round cardboard disc from the template supplied and keep it for later use as a
paint mask, if you decide to paint your speakers.
OWI INC.
INSTALLATION
Speaker Combination Model AMP-BT2SIC5 / AMP-BT2SIC6
(Energy Star)
15
Power Supply
(electrical wire not included)
www.owi-inc.com
Advertisement
Table of Contents
