IT IS THE OWNERS’ RESPONSIBILITY TO ESTABLISH THE DATE OF PURCHASE BY ACCEPTABLE EVIDENCE AT TIME SERVICE IS SOUGHT. 2. Any unit, which in the judgment of OWI INC, is defective or develops defects under normal use will be replaced or repaired without cost within the warranty period.
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Table of Contents Description Page Proprietary, Copyright Notices Unpacking and Inspection Warranty Information Return Shipping Instructions Table of Contents Important Safety Instructions 4 - 5...
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. - This OWI product should be situated so that its location or position does not interfere with its proper ventilation. For example, the component should not be situated on a bed, sofa, rug, or similar surface that may block any ventilation openings, or placed in a built-in installation such as a bookcase or cabinet that may impede the flow of air through ventilation openings.
Page 5
18. OWI recommends that this apparatus be placed on a switched power outlet, one that switches both sides and has contact separation of at least 3 millimeters.
Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Introduction The OWI AMP-BT2SIC5 / AMP-BT2SIC6 is a self powered speaker/amplifier. This unit can drive up to four speakers connected series parallel to have a net impedance of 8 ohms. With an included UL Listed, Level 5 (Energy Star), 15 volt, 3.5 ampere power supply, the amplifier can output 40 watts, or 10 watts per speaker in a four speaker hook-up.
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier SPECIFICATIONS (MODEL AMP-BT2SIC5 / AMP-BT2SIC6) BLUETOOTH SPECIFICATIONS AMP-BT2SIC5 / AMP-BT2SIC6 Certified SIG Bluetooth Version 3.0 Frequency Range 2.40 – 2.48 MHz Supports A2DP, AVRCP, HFP/HSP and SPP...
Page 8
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Mechanical “UL rating is dependent upon use of the Backcan and Tile Bridge” SPECIFICATIONS AMP-BT2SIC5 AMP-BT2SIC6 Speaker Diameter 5.25 inches 6.5 inches Weight of Amplifier/Speaker Assembly 2.55 pounds...
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Illustration: Connection and Control OWI INC. www.owi-inc.com...
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier AMP-BT2SIC5 / AMP-BT2SIC6 TO ANOTHER AMP-BT2SIC5 / AMP-BT2SIC6 SPEAKER WIRING SINGLE LINE DIAGRAM Chained Self Amplified Speakers Wiring OWI INC. www.owi-inc.com...
Open the device Bluetooth manager and review its list of discoverable Bluetooth devices. The speaker amp will appear as OWI-XXXX where XXXX is the last 4 digits of the speaker amp MAC address. Note: The speaker amp MAC address is identified on a label located on the speaker amp board.
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier One, Two, Four Speaker Combination Wiring OWI INC. www.owi-inc.com...
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier INPUT CONNECTORS WIRING Note: Jack Line In is the same as STEREO LINE IN, immediately below. OWI INC. www.owi-inc.com...
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier VOLUME CONTROL WIRING DIAGRAM OWI INC. www.owi-inc.com...
OWI speakers should be located above the primary listening area. Mounting your OWI speakers Determine the best area to mount your OWI speakers. It will be necessary to run your speaker wires to that location. This location must be free of obstructions, such as electrical conduits, HVAC ducts, or water lines.
Page 16
Turn the mounting tab 90° and push toward the grill. The grill will safely pop off. Be sure to position the four Mounting Tabs on your OWI speaker inward then insert the four (4) screws (supplied) from the front of the speaker into the screw opening.
Page 17
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier OWI INC. www.owi-inc.com...
Page 18
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier OWI INC. www.owi-inc.com...
However, we will pay the return shipping charges to any destination within the U.S.A. if the repairs are covered by the warranty. 3. Any unit which in the judgment of OWI Inc. is defective or develops defects under normal use will be replaced or repaired without cost within the warranty period.
OWI User Manual: Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Model AMP-BT2SIC5 / AMP-BT2SIC6 Speaker Amplifier Established 1978 OWI Incorporated 17141Kingsview Ave. Carson CA 90746-1207 USA Tel. 310-515-1900 Fax 310-515-1606 www.owi-inc.com 082114 OWI INC. www.owi-inc.com...