Table of Contents
Advertisement
1.2 System Administration
System Programming and Diagnosis with
Personal Computer
Description
The KX–TD500 system can be programmed and administered using a Personal Computer
(PC). The Programming Guide is required to perform PC Programming. There are two
programming methods:
On–Site Programming
By connecting a PC to your system, System Programming and maintenance can be performed
locally.
There are two ways available to perform the above:
(Method 1.) Using the EIA (RS–232C) port
Connect the PC to the EIA (RS–232C) port provided. The Basic Shelf is provided with RS–
232C Ports. RS–232C Port 1 (PROG) is used for System Programming, diagnostics and
external system database storage (Save / Load) functions, and Port 2 (SMDR) for Station
Message Detail Recording (SMDR) only.
(Method 2.) Using an internal modem
Install the optional Remote Card — ERMT card (KX–TD50197). Connect an extension port
to the modem. Assign the FDN of the modem in System Programming. Dial this number from
the PC.
Remote Programming
You can perform System Programming and maintenance from a remote site using a PC. Install
the Remote Card and assign the Remote FDN by System Programming.
Starting system administration from a remote location can be done using one of the following
ways:
a)
[Call Transfer]
• Call an extension (probably the Operator) from a remote location and request a
b)
[DISA]
• Dial the "FDN of the modem" using the DISA feature.
c)
[DIL 1:1]
• Assign the "FDN of the modem" as the destination of the DIL 1:1 feature.
d)
[DDI / DID]
• Programme DDI / DID feature so that the incoming telephone number is converted
e)
[TIE Lines]
• Dial the "FDN of the modem."
• Dial the TIE Line access code, the PBX Code and the "FDN of the modem."
Features Guide
transfer to the modem.
to the "FDN of the modem."
1.2 System Administration
11
Advertisement
Table of Contents
