Setting The Time Code - Canon XH A1 Instruction Manual

Setting the Time Code

Selecting the Frame Setting
When recording in a mode other than SD at a frame rate of 24F, you can select between a drop frame or
non-drop frame time code.
MENU
SIGNAL SETUP
( 25)
Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then
[FRAME SETTNG]. Select a setting option and close the menu.
When you select the [NON DROP] setting or when you select 24F frame rate in SD mode, "NDF" will appear
on the side panel display.
Selecting the Running Mode
When recording in a mode other than SD at a frame rate of 24F, you can select the running mode of the
camcorder's time code. You can enter the initial value for the [FREE-RUN] and the [REC-RUN PS.]
settings.
[REC-RUN]: The time code runs only when recording.
[REC-RUN PS.]: The time code runs only when recording starting from a preset value.
[FREE-RUN]: The time code runs regardless of the operation of the camcorder.
MENU
SIGNAL SETUP
( 25)
1. Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and
then [COUNT-UP]. Select a setting option and close the menu.
[REC-RUN]: Close the menu.
[REC-RUN PS.], [FREE-RUN]: Continue the procedure below to set the initial value.
2. Select [SET].
The hours display flashes.
3. Set the time code's initial value.
Turn the SELECT/SET dial to set the value for the hours and press the dial. The next field of the display
starts flashing. Set the value for the minutes, seconds and frames in the same way.
4. Close the menu.
About the time code display
- [REC-RUN]:
- [REC-RUN PS.]:
- [FREE-RUN]:
- External Time Code: The time code will be displayed in blue with an
- Time Code Hold:
- Playback:
When you select [FREE-RUN], the time code starts to run the moment you press the MENU button
in the middle of the setting, or when you press the SELECT/SET dial after setting the value for
"frames" in step 3.
To reset the time code to [00:00:00:00], select [RESET] in step 2.
42
TIME CODE
TIME CODE
The time code will be displayed with an
The time code will be displayed in blue with a
The time code will be displayed in blue with an
The time code will be displayed with an
No time code display.
FRAME SETTNG•DROP
COUNT-UP•••••REC-RUN
next to it.
R
next to it.
P
next to it.
F
next to it.
E
next to it.
H