Controls And Functions - BenQ Installation Series User Manual

Controls and functions

Projector
1
2
3
4
5
6
7
8
9
1. Focus ring
Adjusts the focus of the projected image. See
"Fine-tuning the image size and clarity" on page
32 for details.
2. Zoom ring
Adjusts the size of the image. See
the image size and clarity" on page 32
3. Temperature warning light
Lights up or flashes if the projector's
temperature becomes too high. See
on page 53 for details.
4. Power indicator light
Lights up when the projector is in standby mode
or under operation. See
for details.
5. Exit
Exits and saves the menu settings.
6. Left/ Right
Correct keystoning at the top or bottom of the
projected image.
When the on-screen menu is activated, moves
the selection focus left or right, or make
adjustments.
See "Correcting keystone" on page 34
"Using the menus" on page 42
10
6
11
12
"Fine-tuning
for details.
"Indicators"
"Indicators" on page 53
and
for details.
7. Power
I
Turns the projector on or off. See
"Start up" on page 30
down the projector" on page 40
details.
8. Source
Sequentially selects the input signal
Analog RGB, DVI-A, DVI-D,
Analog YPbPr, S-Video, or
Composite Video. See
input signal" on page 31
9. Menu
Turns on the on-screen display
control menu.
When the on-screen menu is
activated, moves the selection focus
down.
See "Using the menus" on page 42
for details.
10. Lamp indicator light
Indicates the status of the lamp.
Lights up or flashes when the lamp
has developed a problem. See
"Indicators" on page 53
11. Blank
Used to hide the screen image. You
can press Blank on the projector or
remote control to bring the image
back. See "Hiding the image" on
page 38 for details.
12. Auto
Automatically determines the best
picture timings for the displayed
image. See "Auto-adjusting the
image" on page 32
Introduction
and "Shutting
for
"Switching
for details.
for details.
for details.
13