Advertisement
4. Flame can be adjusted between "MAX" and "MIN". Please adjust fl ame slowly.
"
火力強弱可在 最大 和 最小 之間調校。請緩慢調校火力。
CAUTION 注意
Don't use it between OFF and MAX
切勿在熄火和最大之間使用
Cannot be positioned between
OFF and MAX
無法安置於熄火與最大之間
5. If the fl ame is extinguished while using, the Flame Failure Safety Device will shut the gas off after a short
delay. When the fl ame was extinguished, please turn the Knob to "OFF" position.
如爐火熄滅 , 防漏熄火安全裝置會自動切斷氣供應 , 如有此情況 ,
6. Don't clean the top of the safety sensor with a hard brush, as it may damage the sensor.
請勿用鋼刷或利器磨擦熄火安全感應頭。
7. Turn the Ignition Control Knob backwards to the "OFF" position to extinguish the burner.
"
將爐掣轉回至 熄火 位置 , 爐火便會熄滅。
HANDLING PROCEDURES WHEN FLAME FAILURE SAFETY DEVICE WORK AND
CHANGE BATTERY
防漏熄火安全裝置生效時的處理方法及更換電芯
1. If the fl ame is extinguished during operation, the automatic Flame Failure Safety Device will shut the gas
off after a short delay.
If you notice that the fl ame has been extinguished, please turn the knob to the "OFF" position.
如爐頭在使用中火焰突然熄滅 , 防漏熄火安全裝置會自動切斷氣供應。
如有此情況 , 請將爐掣轉至 " 熄火 " 位置。
2. The Safety Sensor is delicate, please do not use stiff brushes or rough cleaning pads when cleaning.
安全感應頭十分精密 , 不可用粗糙之刷子或其他東西進行清潔。
* Aeration is preset at Factory, do not attempt to adjust it.
廠方已調校了風位 , 不可自行嘗試調校。
* Battery Box is located at bottom of middle front (Size C, 1.5V × 1)
Open the door of cabinet, and change battery.
電芯盒在爐身的底部中前方。 ( C 型 , 1.5 伏特 × 1)
請將盒蓋打開更換電池。
* Set battery correctly with care ⊕ .
請小心別把乾電池的 ⊕ 弄錯。
RB-11G-C.indd Sec1:5
RB-11G-C.indd Sec1:5
" "
"
"MAX" position
最大位置
"
Front Side
"MIN" position
最小位置
Range of use
使用範圍
前面
– 5 –
"
"
請將爐掣轉至 熄火 位置。
2/10/2009 9:04:57 AM
2/10/2009 9:04:57 AM
Advertisement
