When The Self-Clean Cycle Is Completed; Stopping Or Interrupting A Self-Cleaning Cycle - Frigidaire PLCS389ECE Control Manual

Oven Cleaning
INSTRUCTIONS

When the Self-Clean Cycle is Completed

1. The time of day,"END", "DOOR LOCKED" and "CLEAN" will remain
in the display.
2. Once the oven has cooled down for approximately 1 HOUR, and
"DOOR LOCKED" is no longer displayed, the oven door can then be
opened.

Stopping or Interrupting a Self-Cleaning Cycle

If it becomes necessary to stop or interrupt a self-cleaning cycle due to
excessive smoke or fire in the oven:
Clear/Off
1. Press .
Annuler
2. The oven door can only be opened after the oven has cooled down for
approximately 1 HOUR and "DOOR LOCKED" is no longer displayed
(Figure 1).
IMPORTANT NOTES when using the Self-Clean feature:
1. On some models, the Self-Clean feature will not operate whenever a radiant surface
remains ON.
2. On some models, starting a self-clean cycle will turn ON the Cooktop Lockout feature.
If it is the case the symbol
that the Cooktop Lockout feature is ON. The cooktop will remain locked until the Self-
Clean cycle has completed and the oven door has unlocked.
3. A Self-Clean cycle cannot be started if Oven Lockout feature is active.
4. If a Self-Cleaning Cycle has started but not finished and a power failure occurs, the
appliance may not have thoroughly cleaned. Once power is restored, the oven door and
the cooktop are unlocked. Then set for another Self-Clean cycle to finish.
5. If your clock is set for normal 12 hour display mode the Delay Self-Clean cycle can
never be set to start more than 12 hours in advance. To set for a delayed Self-Cleaning
cycle 12-24 hours in advance set the control for the 24 hour time of day display mode.
(continued)
will appear in the display (Figure 2) which will indicate
PRESS
Clear/Off
Annuler
19
DISPLAY
Figure 1
Figure 2