Preparation; Installing The Channel Stopper; Installing The Antenna - Kenwood TK-D348R User Manual

INSTALLING THE CHANNEL STOPPER

You can set the channel stopper position for channels 2, 4, 6, 8, 10, 12, and 14.
Inserting the Channel stopper prevents unnecessarily selecting channels which
do not exist.
• Selecting a channel which does not exist causes a continuous error tone to
sound.
1 Set the Channel selector to channel 1, then pull the Channel selector knob off
the transceiver.
• If the Channel selector is not positioned at channel 1, the knob may not
install correctly and the channel may be unable to change.
2 Insert the channel stopper.
3 Set the arrow of the Channel stopper to the highest channel number for the
transceiver.
4 Reinsert the Channel selector knob.

INSTALLING THE ANTENNA

Antenna

PREPARATION

Screw the antenna into the connector on the top of the
transceiver by holding the antenna at its base and turning it
clockwise until secure.
Note:
◆ The antenna is neither a handle, a key ring retainer, nor a
speaker/ microphone attachment point. Using the antenna
in these ways may damage the antenna and degrade your
transceiver's performance.
Arrow
Channel stopper
4