Table of Contents
Advertisement
Preparation
Installation
1.
Perform Pressure Relief Procedure.
2.
Unplug unit and ensure the power switch
is set to off.
3.
Remove the hopper, front shroud, and
rear shroud.
4.
Cut the zip ties holding the flowswitch to
the unit, unhook the flowswitch from the
air and electrical systems, and remove
the flowswitch. Removing the pressure
switch is optional.
NOTE: Removing one or both tires from the
unit will make it significantly easier to access
the back of the flowswitch.
6
5.
Fasten the new flowswitch assembly to
the unit using the provided bolts as
shown below. Torque each bolt to 27-32
in-lb (31.-3.6 N•m).
6.
Connect the flowswitch assembly to the
air and electrical system, following the
provided diagrams.
7.
Neatly secure the wiring using the
provided zip ties, such that it does not
pinch or interfere when replacing the
back shroud.
8.
Assemble back shroud, front shroud,
and hopper to the unit.
3A7027A
Advertisement
Table of Contents
