Before Starting; Normal Installation Steps; Anti-Tip Bracket Installation Instructions Important Safety Warning - Frigidaire Gallery FGGF304DLF Install Manual

30" GAS RANGE INSTALLATION INSTRUCTIONS

Before Starting

Tools you will need
For leveling legs and anti-tip brackets:
● Adjustable wrench or channel lock pliers
● 5/16" Nutdriver or Flat Head Screw Driver
● Electric Drill & 1/8 Diameter
Drill Bit (5/32" Masonry Drill
Bit if installing in concrete)
● Level & Measuring Tape
For gas supply connection:
● Pipe Wrench
● Brush
For burner flame adjustment:
● Phillips head
screwdrivers
For gas conversion (LP/Propane or Natural):
● Open end wrench - 1/2"
Additional materials you will need:
● Gas line shut-off valve
● Pipe joint sealant that resists action of LP/
Propane gas
● A new flexible metal appliance conduit (½" NPT x
¾" or ½" I.D.) must be design certified
by CSA International. Because solid pipe
restricts moving the range we recommend
using a new flexible conduit (4 feet length)
for each new installation and additional
reinstallations.
● Always use the (2) new flare union
adapters ½" NPT x ¾" or ½" I.D.) supplied with the
new flexible appliance conduit for connection of the
range.

Normal Installation Steps

1
Anti-tip Bracket Installation
Instructions Important Safety Warning
To reduce the risk of tipping of the range, the range must
be secured to the floor by the properly installed anti-tip
bracket and screws packed with the range. Failure to
install the anti-tip bracket will allow the range to tip over if
excessive weight is placed on an open door or if child climbs
upon it. Serious injury might result from spilled hot liquids
or from the range itself.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Instructions are provided for installation in wood or
cement floor. When fastening to floor, be sure that
screws do not penetrate electrical wiring or plumbing.
and blade-type
A. Locate the Bracket Using the Template - Locate
the bracket position (right or left side) by placing the
template symmetrically to the center of the final range
position. Mark the location of the screw holes, shown on
template.
B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8"
pilot hole where screws are to be located. If bracket is to
be mounted to the wall, drill pilot hole at an approximate
20° downward angle. If bracket is to be mounted to
masonry or ceramic floors, drill a 3/16" pilot hole 1-3/4"
deep. The screws provided may be used in wood or
concrete material. Use a 5/16" nut-driver or flat head
screwdriver to secure the bracket in place.
3
Figure 1
Figure 2