INSTALLATION
AND SERVICE
MUST
BE PERFORHED
BY A QUALIFIED
INSTALLER,
IMPORTANT:
SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S
USE,
READ AND SAVE THESE
INSTRUCTIONS
FOR FUTURE
REFERENCE,
FOR YOUR SAFETY: Do not store or use gasoline or other
flammable
vapors
and liquids in the vicinity of this or any other
appliance.
If the information in this manual is not followed
exactly, a fire or explosion may result causing property damage,
personal injury or death.
FOR YOUR SAFETY:
=
Do not store or use gasoline or other flammable
vapors and
liquids in the vicinity of this or any other appliance.
=
WHAT TO DO IF YOU SMELL GAS:
=
Do not try to light any appliance.
=
Do not touch
any electrical
switch; do not use any phone in
your building.
=
Immediately
cail your gas supplier from a neighbor's
phone.
Follow the gas supplier's
instructions.
=
If you cannot reach your gas supplier, call the fire department.
--
Installation
and service must be performed
by a qualified
installer, service agency or the gas supplier.
• All appliances can tip.
• Injury to persons
could result.
® Install anti=tip
bracket p_cked with
your appliance.
• See Installation
Instructions.
Note: For appliance installed in the
State of Massachusetts see page 2.
Front
view
49"
Maximum
A_
36 -+ 1/8"
/
,\
* 30" minimum clearance between the top of the cooking
surface and the bottom of an unprotected wood or metal
cabinet; or 24" minimum when bottom of wood or metal
cabinet is protected by not less than 1/4"flame retardant
millboard covered with not less than no. 28 NSG sheet
steel, 0.015" stainless steel, 0.024" aluminum or 0.020"
copper. The minimum clearance is 0" for the rear of the
range. Follow all dimension requirements provided above
to prevent property damage, potential fire hazard, and
incorrect countertop and cabinet cuts.
Clearances and Dimensions
1. Location--
h
k l
i nwh
r
h
r n
will
Check for proper electrical and gas supply, and
the stability of floor.
Printed in United States
Avoid locating
cabinet
storage
space above
the
surface burners to eliminate the possibility of cabinets
catching on fire, or personal burns from reaching for
the cabinets over the heated units, Avoid locating
cabinet
storage
space above the surface burners,
The absence of cabinets will eliminate the chance of
cabinets catching on fire, and eliminate the possibility
of receiving
personal
burns from reaching
for the
cabinets
over flaming
surface
burners,
If cabinet
storage
is to be provided,
risk can be reduced by
installing
a range hood that projects horizontally
a
minimum of 5" beyond the bottom of the cabinets,
2. Dim n i n
h
r
h wnm
.Given
dimensions
provide
minimum
clearance.
Contact
surface must be solid and level.
318201792 (1005) Rev. A