Table 124 Advanced Application > LLDP > LLDP Configuration
LABEL
*
Admin Status
Notification
Apply
Cancel
31.6.1 Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP Configuration
(Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 177 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
The following table describes the labels in this screen.
Table 125 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL
Port
*
Management
Address
Port Description
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select whether LLDP transmission and/or reception is allowed on this port.
•
Disable - not allowed
•
Tx-Only - transmit only
•
Rx-Only - receive only
•
Tx-Rx - transmit and receive
Select whether LLDP notification is enabled on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This displays the Switch's port number. * means all ports.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select the check box(es) to enable or disable the sending of Management Address TLVs on
the port(s).
Select the check box(es) to enable or disable the sending of Port Description TLVs on the
port(s).
XS1930 Series User's Guide
250