Part 5. Programming Mode - LG TD-V10137E Owner's Manual

Part 5 PROGRAMMING MODE
1 1
Programming mode
You can check machine information or change setting on Program setup or Diagnostic test.
There are two methods that you can enter programming mode.
2 2
Check the programming mode by button
How to enter "Programming mode"
You can enter programming mode
only for Idle state and pause state.
- Noncoin type
1) Push the WHITES AND COLORS and DELICATES
button at the same time
2) Push the PERMANENT PRESS button 3times.
3) Push the START button.
4) 'LqC1' will show on the display.
Note
• If you turn on the power without connecting the meter case for the first time, the machine will display
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode's
1 2
NONCOIN TYPE
How to use button
You can change Dryer vend price, cycle time and
Cycle parameters, etc.
Press button
WHITES AND
COLORS
PERMANENT
PRESS
DELICATES
START
.)
Description
Move to upper level
Move to the mode in the
same level (+)
Move to the modes in the
same level (-)
Enter the selected mode
.