Maintenance; Blade Replacement; Blade Guard; Blade Oiler Pad - 3M 39600 Instructions And Parts List

Maintenance

•
To reduce the risk associated with shear, pinch, and entanglement hazards:
−
Turn air and electrical supplies off on associated equipment before performing any adjustments,
maintenance, or servicing the taping heads
−
Never attempt to work on the taping head or load tape while the box drive system is running
•
To reduce the risk associated with sharp blade hazards:
−
Keep hands and fi ngers away from tape cutoff blades under orange blade guards. The blades are
extremely sharp
The AccuGlide™ STD 2+ 3 Inch Taping Head
has been designed for long, trouble free service.
The taping head will perform best when it receives
routine maintenance and cleaning. Taping head
components that fail or wear excessively should be
promptly repaired or replaced to prevent damage to
other portions of the head or to the product.
Blade Replacement, Upper and Lower Taping
Heads – Figure 4-1.
WARNING
•
To reduce the risk associated with
sharp blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blade edge. The knives are extremely
sharp
1. Loosen, but do not remove, the blade screws
(A). Remove and discard old blade.
2. Mount the new blade (B) with the beveled side
away from the blade holder.
Knife
Guard
Figure 4-1 – Blade Replacement
2+ STD 3" Taping Head - NA
WARNING
3. Bottom the blade slots against the screws. (This

Blade Guard

The blade guard covers the blade whenever a box
is not being taped. Periodically check to be sure the
blade guard is functioning properly and returning to
cover the blade. Replace any defective parts.

Blade Oiler Pad

To reduce adhesive build-up, the taping heads are
equipped with a factory pre-lubricated felt oiler pad
that provides a fi lm of oil on the cutting edge of the
blade. Blade maintainance should include keeping
the felt oiler pad saturated with SAE #30 non-
detergent oil.
Should tape adhesive build-up occur on blade,
Knife
carefully wipe clean with an oily cloth.
Holder
12
will position the blade at the correct angle.)
Tighten the blade screws to secure the blade.
Note – Check the blade position to insure
proper clearance between blade and guard
by slowly pivoting the blade guard back.
WARNING
•
To reduce the risk associated with
sharp blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blade edge. The knives are extremely
sharp
2011 December