Drive Pulley Ring; Drive Belt Tension - 3M 39600 Instructions And Parts List

13-MAINTENANCE AND REPAIRS (continued)
13.9 Box Drive Belt Tension and
Drive Pulley Rings
Before installing a new belt, check the orange plastic
drive pulley rings for wear. If torn, broken, or worn
smooth, replace the rings (Figure 13-5).
To reduce the risk associated with mechanical and electrical hazards:
•
 
Turn electrical supply off and disconnect before performing any adjustments,
maintenance or servicing the machine or taping heads.
13.10 Box Drive Belt Tension
The two (2) continuously moving drive belts convey boxes through the tape applying mechanism.
The box drive belts are powered by an electric gear motor.
Tension adjustment of these belts may be required during normal operation (for Belt Tension Adjustment - refer to
Section 11 / Set-Up and Adjustments). Belt tension must be adequate to positively move the box through the
machine and the belts should run fully on the surface of the pulleys at each end of the frame. The idler pulleys on
the infeed end are adjusted in or out to provide proper belt tension. Each belt is adjusted separately.
Belt tension is obtained by tightening the adjustment screw so that a moderate pulling force of 3.5kg [7lbs.]
applied at the mid span, as shown in Figure 13-6, will defl ect the belt 25mm [1 inch]. This will assure positive
contact between the belt and the drive pulley on the discharge end of the drive assembly.
Discharge End
Figure 13-6 Box Drive Belt Tension Adjustment
200a3-NA
WARNING
Box Drive Belt
Figure 13-5
3.5kg (7lbs) Pull Force
with 25mm (1 inch) at Mid span
(Belt Tension - continued on next page)
31
Infeed End
2011 June