[Quick Startup]; [No Signal Setting] - Panasonic PT-MZ10K Operating Instructions Manual

f When [ECO] is set, it may take approximately 10 seconds longer before the projector starts projecting after the power is turned on,
compared with when [NORMAL] is set.
f When [NORMAL] is set, power can be supplied using the <DC OUT> terminal even while the projector is in the standby mode. If [ECO] is
set, power cannot be supplied in the standby mode.

[QUICK STARTUP]

Enable/disable the [QUICK STARTUP] function.
1) Press as to select [QUICK STARTUP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
f Proceed to Step 3) when [ON] is selected.
3) Press the <ENTER> button.
f The [QUICK STARTUP] screen is displayed.
4) Press qw to switch [VALID PERIOD].
f The items will switch each time you press the button.
[30MIN.]
[60MIN.]
[90MIN.]
Note
f [QUICK STARTUP] cannot be set when [STANDBY MODE] is set to [ECO].
f When [QUICK STARTUP] is set to [ON], the power consumption during standby becomes high during the period when the [QUICK
STARTUP] function is valid.
f When [QUICK STARTUP] is set to [ON], the [QUICK STARTUP] function is disabled when the time set in [VALID PERIOD] elapses after the
projector enters the standby mode. The startup time and power consumption will be the same as when [QUICK STARTUP] is set to [OFF].
f When [QUICK STARTUP] is set to [ON], the power indicator <ON (G)/STANDBY (R)> blinks in red while in the standby mode during the
period when the [QUICK STARTUP] function is valid. The power indicator <ON (G)/STANDBY (R)> lights up in red when the specified time
set in [VALID PERIOD] elapses after the projector enters the standby mode.
f When [QUICK STARTUP] is set to [ON], the period when the [QUICK STARTUP] function is valid is counted as the projector runtime.

[NO SIGNAL SETTING]

Set the operation of the function when there is no input signal.
[BACKUP INPUT SETTING]
Set the backup function that switches the signal to the backup input signal as seamless as possible when input
signal is disrupted.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [BACKUP INPUT SETTING].
4) Press the <ENTER> button.
f The [BACKUP INPUT SETTING] screen is displayed.
5) Press as to select [BACKUP INPUT MODE].
6) Press the <ENTER> button.
f The [BACKUP INPUT MODE] screen is displayed.
7) Press as to select the combination of the input and press the <ENTER> button.
132 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the [QUICK STARTUP] function.
Enables the [QUICK STARTUP] function until the specified time set in [VALID PERIOD] elapses after
the projector enters the standby mode. The time until the projection starts after the power is turned on
will be reduced during the period when the [QUICK STARTUP] function is valid.
Sets the time until the [QUICK STARTUP] function is disabled after the projector enters the standby
mode.
Select a desired valid period.