Serial Number Location; Unit Dimensions; Component Locations; About Pwrcell Inverters - Generac Power Systems PWRcell XVT076A03 Installation And Owner's Manual

General Information

Serial Number Location

Refer to Figure 2-2 to locate unit serial number (D).
Record the information from this tag in
Inverter Important Information
of this manual.

Unit Dimensions

A
B
Figure 2-1. Unit Dimension
A
24-3/4 in (628 mm)
B
19-3/8 in (491 mm)
C
8-3/8 in (214 mm)

About PWRcell Inverters

The PWRcell Inverter connects PV Link™ optimizers and PWRcell Batteries to form the PWRcell system for grid-
interactive solar-plus-storage. Upon the loss of utility grid power, PWRcell Inverters disconnect from the grid and
provide AC power to support protected loads when configured to do so. This capability is referred to as islanding. For
more information, see Island Mode
PWRcell Inverters use the REbus™ 380 VDC nanogrid to connect DC-coupled PWRcell devices. The REbus nanogrid
automates the flow of power to enable plug-and-play setup and operation of PWRcell equipment. For more information
about REbus, visit www.generac.com. In
(B) and PWRcell Battery (C) on DC (REbus) lines (D). To the right of the inverter are AC lines: 120/240 VAC or 208
VAC for grid and home loads (G) and protected loads (H).
.
A
B B
A Solar Panels
B PV Link
C PWRcell Battery
6
Table 1: PWRcell
on the inside front cover
C
009955
in Section 6:Commissioning.
Figure 2-3
C
D
B
Figure 2-3. Generac PWRcell System Example
D REbus
E PWRcell Inverter
F
Grid

Component Locations

A
B
Figure 2-2. Component Locations
A
Control Panel
B Intake Filter
C Exhaust Vent
D Serial Number Tag
PWRcell Inverter (E) is directly connected to PV Link optimizers
E
D
G
H
Installation and Owner's Manual for Generac PWRcell Inverter
F
Loads
Protected Loads
C
D
009654
G
H
009893