Canon WFT-E3 Instruction Manual page 20

Following the Connection Wizard
Selecting the LAN Type
Wireless LAN
Active wireless LAN devices in your area are found and listed.
Wired LAN
The [Network] settings screen is displayed. If you have selected a wired network, refer to page
22, "Configuring Network Settings."
Use a Category 5 or higher STP LAN cable. (STP: Shielded Twisted Pair)
Selecting the Wireless Network
Wireless LAN devices are listed with identifying information. Select the SSID (or ESS-ID) of
your desired wireless LAN device.
1 2 3
1
Indicates whether the device is in infrastructure or ad hoc mode
2
An icon is displayed if the wireless LAN device is encrypting communication
3 Indicates the first 9 characters of the SSID
4
Indicates the channel used
Encryption by Wireless LAN Devices
If the wireless LAN device is encrypting communication, select the corresponding method in
[Authentication] and [Encryption].
[Authentication]: Open system, Shared key, WPA-PSK, or WPA2-PSK
[Encryption]: WEP, TKIP, or AES
20
Turn the <5> dial to select the type of LAN, and
then press <0>.
Select [OK] and press <0> to go to the next
screen.
To select the wireless LAN device, press <0>.
4
Turn the <5> dial to select the wireless LAN
device, and then press <0>.
Select [OK] and press <0> to go to the next
screen.