Table of Contents
Advertisement
June 13, 2008 Final Draft
Thermal paper: The paper used in the thermal receipt station must meet the
following requirements:
Width 79.5 ± 0.5 mm (3.13 ± 0.02 in.)
Outside Diameter
Thickness
The paper must be wound with the printing side facing out. The paper should not
be attached to the core in any manner. A red stripe of 1.5 to 2.1 m (5 to 7 ft.)
should indicate the end of the roll.
Note: Papers that meet these criteria include Appleton Optima POS and Seiko
Document insert forms:
Note: Models 2CR and 2NR support up to three parts on a multipart form.
Table 7 on page 22 list the specifications of supported single and multipart forms.
Notes:
1. Test all forms in the printer to ensure acceptable performance prior to buying a
2. No binding holes or other holes should be within 10 mm (0.4 in.) from the right
3. Forms less than 0.15 mm (0.006 in.) thick with the grain of the paper
102 mm (4.0 in.) maximum
60 Μ (0.00225 in.) Range: 41 Μ minimum to 99 Μ maximum
Important
Paper has a significant manufacturing tolerance and nominal paper
designations do not reflect actual measurements. The manufacturing
tolerance must fall within the published operating thickness range. IBM
strongly recommends that customers test paper in their specific
configuration before use. The intent of this specification is that if any
spot measurement of the paper is outside the specified range, the
paper is deemed not to meet the specification and the customer is
responsible for any problems caused by paper jams.
(Jujo) papers.
Important
Printer reliability and performance are directly related to the quality of the
supplies used by the customer. The published parameters for printer
performance are established using supplies that meet the specifications listed
above.
Thermal paper with watermarks, coupons, or advertisements printed on the
front or back of the paper is not covered by IBM specifications. Some inks
and printing processes will work acceptably, while others will not. Printer
problems that are caused by supplies that do not meet IBM specifications may
result in a billable service call, regardless of the existence of a service
contract.
significant quantity.
edge of the form.
DRAFT
perpendicular to the feed direction (short-grain paper) should not be used for
landscape printing.
Using and maintaining the 4610
Chapter 3. Using and maintaining the 4610
21
Advertisement
Table of Contents
