Paper Roll Placement - IBM 2CR User Manual

Using and maintaining the 4610
Figure 14. Paper roll placement
3. See Figure 14 and place the paper roll into the paper roll bucket as shown. The
4. Close the paper cover.
5. Press the customer receipt feed button to advance the paper, to verify that the
Attention:
cover closed. This disengages the paper feed. The paper feed motor must then
catch up before the printer can feed the paper, which causes missing lines or partial
lines of print. Use the customer receipt feed button to advance the receipt and all
lines will print.
Supported paper types
Attention:
life of printheads and the printer mechanism.
Note: When selecting a paper, ensure that the paper's archive life meets the
20
SureMark 4610 Printers: User's Guide for Models 2CR and 2NR
Note: Refer to the label on the inside of the paper cover for a diagram of how
to load paper.
leading edge of the paper should come from the bottom of the roll as shown in
the diagram.
Note: The thermal printhead will not print on paper with glue on it. If the new
paper roll was sealed by glue, tear off the 6 to 8 inches of paper with
glue on it before loading it.
paper is feeding correctly. Feed 30 cm (about 1 ft.) of paper through to test for
correct alignment.
Do not pull the receipt paper out of the printer with the paper access
Using an inferior grade of paper can affect print quality as well as the
requirements of the tax authorities of your country for archiving tax-related
DRAFT
data.
June 13, 2008 Final Draft