IBM 2CR User Manual page 30

Installing 4610 Models 2CR and 2NR
2. Move the display on its arm to the side and remove any tape holding the
3. Remove the knockout section of the display filler.
4. Align the display filler with the alignment ring and slide the filler onto the ring.
5. If you do not have a display, place the display filler on the system unit.
6. If you have a short keyboard, place the keyboard filler beside the keyboard. See
7. Place the printer filler beside the display filler. Make sure you route the printer
18
SureMark 4610 Printers: User's Guide for Models 2CR and 2NR
alignment ring.
Press the display filler into place. See Figure 12 on page 17.
Figure 12 on page 17.
cable to the side, as shown in Figure 12 on page 17.
DRAFT
June 13, 2008 Final Draft