Advertisement
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND: *ZxxTREByyy<CR> – zone xx TREBLE EQ with yyy = EQ level, dB, –12 to
+0 (flat) to +12 in 2 dB increments. USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN
10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPON<CR> – zone xx SOURCE GROUP ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPON<CR> – zone xx SOURCE GROUP ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxGRPOFF<CR> – zone xx SOURCE GROUP OFF.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxVRSTON<CR> – zone xx VOLUME RESET ON.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxVRSTOFF<CR> – zone xx VOLUME RESET OFF.
RESPONSE:
Same response as for *ZxxSETSR<CR>
NOTE: sending this command to the E6D will set override (lock out KEYPAD non-address DIP
switches) for this zone until power is cycled.
*********************************************************************************
COMMAND:
*ZxxLKON<CR> – zone xx KEYPAD LOCK ON – This will INHIBIT ANY keypad
control input on the zone. This is the same as activating the Parental lock control at a keypad by
holding down a SOURCE key for three seconds).
RESPONSE:
#ZxxLKON<CR>
*********************************************************************************
5
Advertisement
