Advertisement
*********************************************************************************
COMMAND:
*ALLHLD<CR> – Stops ramp action initiated by *ALLV+<CR> Or *ALLV-<CR>
RESPONSE:
#ALLHLD-<CR>
This results in a HOLD of the level at time of command receipt.
*********************************************************************************
COMMAND:
*ALLMON<CR> – ALL MUTE ON.
RESPONSE:
# ALLMON<CR>
*********************************************************************************
COMMAND:
*ALLMOFF<CR> – ALL MUTE OFF.
RESPONSE:
#ALLMOFF<CR>
********************************************************************************
COMMAND:
*ZxxSRCp<CR> – Switch zone xx to SOURCE p ( 1 to 6).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxVOLyy<CR> – Set volume of zone xx to level yy below max in dB from –0
to –78 dB (include lead 0 for all single-digit values).
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxVOL+<CR> – STARTS zone xx volume ramp UP at the rate of +10 dB per
second in +1 dB steps. (This is the same as holding VOLUME UP key on a KEYPAD for 1
second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVOL-<CR> – STARTS zone xx volume ramp DOWN at the rate of -10 dB
per second in -1 dB steps. (This is the same as holding VOLUME UP key on a KEYPAD for 1
second).
RESPONSE:
Same response as for *ZxxCONSR<CR>, updated 10 times per second.
*********************************************************************************
COMMAND:
*ZxxVHLD<CR> – STOPS zone xx volume ramp initiated by *ZxxVOL+<CR> or
*ZxxVOL-<CR> commands. This results in a HOLD of the level at time of command receipt.
RESPONSE:
#ZxxVHLD<CR>
*********************************************************************************
COMMAND:
*ZxxMTON<CR> – zone xx MUTE ON (mutes currently connected source)
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxMTOFF<CR> – zone xx MUTE OFF (returns zone output to currently
RESPONSE:
Same response as for *ZxxCONSR<CR>
*********************************************************************************
COMMAND:
*ZxxBASSyyy<CR> – zone xx BASS EQ with yyy = EQ level, dB, –12 to
+0 (flat) to +12 in 2 dB increments. USE LEAD "0" IN TENS PLACE FOR VALUE LESS THAN
10.
RESPONSE:
Same response as for *ZxxSETSR<CR>
connected source at previous volume setting).
4
Advertisement
