Advertisement
(266°F ~ 302°F)
(130°C ~150°C) for about 2 minutes.
Note:
A. Leadless components must not be reused after removal.
B. Excessive mechanical stress and rubbing of the component
electrode must be avoided.
2. Removing the leadless component
Grasp the leadless component body with tweezers and alternately
apply heat to both electrodes. When the solder on both electrodes
is melted, remove the leadless component with a twisting motion.
Note:
A. Do not attempt to lift the component off the board until the
component is completely disconnected from the board by a
twisting action.
B. Be careful not to break the copper foil on the printed circuit
board.
3. Installing the leadless component
A. Presolder the contact points on the circuit board.
B. Press the part downward with tweezers and solder both
electrodes as shown below.
Note:
Do not glue the replacement leadless component to the circuit
Fig. 8-1
Fig. 8-2
Fig. 8-3
17
Advertisement
