Table of Contents
Advertisement
Your projector is equipped with various audio/video inputs and outputs including Computer HDB15pin (VGA) terminals,
Monitor HDBl5-pin (VGA) terminals and S-VHS video .
CONNECTING THE COMPUTER
CONNECTING TO THE COMPUTER INPUT HDB15-PIN (VGA) TERMINALS (1 and 2)
Personal computers can be connected to the HDBl5pin (VGA) terminal on the projector.
Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
l
CONNECTING TO THE MONITOR OUTPUT HDBl5-PIN (VGA) TERMINAL
This terminal contain the information that is viewed on the screen.
Monitor can be connected to the HDBl 5pin (VGA) terminal on the projector.
Connect the monitor to this terminal using the monitor cable (not provided).
l
TERMINAL
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
.
Connect audio outputs from your computer to these jacks using the audio cable (not provided).
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
If vou wish to control the computer with projector's remote control unit, you must connect control port (PW2, Serial or
l
n
CONTROL PORT
7 4
by computer, you must connect control port 2 connector.
CONNECTING THE PROJECTOR
0 0 0 0 0
Serial
Port
Port
1
2
CLK
3
DATA
a
6
7
READY
6
9
GND
GND
10
Pin NoJSignal
Red input
Green input
Blue input
Sense 2
Ground (Horiz. sync.)
Ground (Red)
Ground (Green)
Ground (Blue)
ADB
Port
CONTROL PORT CABLE
ADB
REMOVAL HINT
Disconnect control port cable
with following steps.
connector with one hand.
2. Pull the portion (B) arrow
direction and remove
GND
connector.
Pin NoJSignal
9 Non Connect
10 Ground (Vet?. sync.)
11 Sense 0
12 Sense 1
13 Horiz. sync.
14 Vet-t. sync.
15 Reserved
1
B
Advertisement
Table of Contents
