3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
5.
Use (B) and (D) to change the minutes
setting.
6.
Press (A) to complete the setting
operation.
Note
Setting a start time of "0:00" will
●
perform a countdown of 24 hours.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 5553
Using the Timer
The timer counts down time in 1-second units.
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
(Measurement operation starts.)
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (A).
3.
Press any button to stop the tone.
Seconds
Hours
Minutes
D
Start
D
Pause
D
Resume
(Time up)
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Adjusting Hand Alignment
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least five seconds.
Release the button when [Sub] starts to
flash.
This enables adjustment of stopwatch
hand alignment.
After two seconds
After five seconds
Stopwatch hand
3.
If the stopwatch hand is not at 12 o'clock,
use (B) and (D) to align it.
Holding down (B) or (D) moves the hand
●
at high speed.
4.
Press (C).
This enables adjustment of the hour and
minute hands.
Minute hand
Hour hand
5.
If the hour and minute hands are not at 12
o'clock, use (B) and (D) to align them.
6.
Press (A) to complete the setting
operation.
14