Kurzweil PC2 Series Service Manual page 15

Sound / Setup Select
Internal MIDI KB3
Voices Setups Mode
Previous Next
Group Group
Figure 1-5
Sound/Setup Select—Three groups of buttons are included in this section. Use the buttons in
the first group to select one of the three performance modes: Internal Voices, MIDI Setups, or
KB3 Mode. The second group, Previous Group and Next Group, is for use in the Internal Voices
and MIDI Setups modes only. Depending on which mode you're in, they select the previous or
next group of programs or setups. Use the buttons in the third group, labelled 1–16, to select a
category of Internal Voice programs or MIDI setups. In KB3 Mode, use these buttons to select
one of the 16 KB3 programs.
Effects and Reverb—Use the buttons in this section to select from two blocks of effects to apply
effects and reverb to programs and setups.
Figure 1-6
Data Entry—This section contains the Alpha Wheel, Minus (-) and Plus (+) buttons, and the
Alphanumeric keypad. Use the Alpha Wheel or the Minus (-) and Plus (+) buttons to increase or
decrease a value. Use the buttons in the Alphanumeric keypad to enter text, numbers, spaces,
etc. This section also includes the Cancel (No) and Enter (Yes) buttons.
Mod/Pitch Wheel Assembly (not shown)—Use the two wheels to vary modulation and pitch.
Also included on the assembly is the SW4 and SW5 switches for use in the Internal Voices and
MIDI Setups modes.
Piano 1 Piano 2 E Piano 1 E Piano 2
1 2 3
Strings Voices Synths Pads
9 10 11 12
Sound/Setup Select and Effects and Reverb sections
Data Entry
Data Entry section
Pop Keys Clavier Organ
4 5 6 7
Guitar Bass Drums
13 14 15
Demo
1 2
A B C D E F G H I
4 5
J K L M N O P Q R
7 8
S T U V W X
+ / - 0 Clear
UPPER / lower 0 - 9 Space
Cancel Enter
No
Effects and Reverb
Brass
FX-A
8
Mute A
Percussion
FX-B
16
Mute B
3
6
9
Y Z
Yes
Introduction
PC2/PC2X
Select Wet / Dry
Select FX Mode
1-5