Focus Settings - Sony a7s II How To Use Manual

3. [amount] → desired value.
You can select a value between −20 and +20. The larger the value you select, the
farther the autofocused position will be from the product. The smaller the value you
select, the closer the autofocused position will be to the product.
Note
It is recommended that you adjust the position under actual shooting conditions.
When you attach a lens for which you have already registered a value, the registered
value appears on the screen. [±0] appears for lenses for which a value has not yet been
registered.
If [−] is displayed as the value, then a total of 30 lenses have been registered and no new
lens can be registered. To register a new lens, attach a lens for which the registration can
be erased, and set its value to [±0], or reset the values of all the lenses using [Clear].
The [AF Micro Adj.] supports Sony, Minolta, or Konica-Minolta lenses. If you perform [AF
Micro Adj.] with lenses other than the supported lenses, the registered settings for the
supported lenses may be affected. Do not perform [AF Micro Adj.] with an unsupported
lens.
You cannot set [AF Micro Adj.] individually for a Sony, Minolta, and Konica-Minolta lens of
the same specification.
[84] How to Use

Focus Settings

Sets up the focus functions. The setting applies to both still images and movies.
1. MENU →
2. Perform settings using the front/rear dial or control wheel.
When the focus mode is set to [Autofocus]/[DMF]
Front dial: Moves the focus area frame up/down.
Rear dial: Moves the focus area frame right/left.
Control wheel: Selects the focus area.
When the focus mode is set to [Manual Focus]
You can set the area to be magnified when focusing manually.
Front dial: Moves the area to be magnified up/down.
Rear dial: Moves the area to be magnified right/left.
Using shooting functions
(Camera Settings) → [Focus Settings].
Adjusting the focus