Feeding Trouble - Canon IMAGEFORMULA CR-190I Instructions Manual

Feeding Trouble

If the document is not fed properly or the detection functions do not
work properly, remedy the problem by checking the following
conditions.
Condition A paper jam has occurred.
Cause and • Check to make sure that the size and thickness of the
Remedy document are within the supported range of the
scanner, and if the quality of the paper is appropriate.
For cautions on handling documents, see
"Documents," on p. 31.
• Documents with rough surfaces may cause a paper
feed error to occur.
Scan one sheet at a time in the separation OFF mode.
(See "Separation OFF Mode," on p. 37.)
• Dirty or worn rollers inside the scanner may cause a
paper jam.
Clean the rollers if they are dirty. (See "Cleaning the
Scanning Glass and Rollers," on p. 45.) Worn rollers
must be replaced. Some rollers are replaceable. (See
"Replacing the Rollers," on p. 53.) If the rollers are not
replaceable, contact your local authorized Canon
dealer or service representative to have the scanner
serviced.
• The Separation Roller gap is too wide. Adjust the
Separation Roller gap. (See "Adjusting the Separation
Roller Gap," on p. 57.)
Condition A double feed error occurred even though
documents are not being double fed.
Cause and A double feed error may occur when documents with
Remedy different thicknesses are mixed. Turn OFF the double
feed detection mode, if this happens.
Condition MICR characters are not recognized correctly.
Cause and • The scanner cannot correctly read MICR characters if
Remedy the magnetic heads are dirty. Clean the MICR
magnetic heads. (See "Cleaning the Magnetic Heads,"
on p. 48.)
• If MICR characters cannot be recognized correctly
after cleaning the heads, the MICR heads may be
worn. Contact your local authorized Canon dealer or
service representative to have the scanner serviced.
• The MICR text is on the back of the document. Load the
side with the MICR characters face up in the document
tray.
Other • Some of the MICR characters are scratched or missing.
Causes Splattered MICR ink or toner may also be the problem.
Condition The imprinter is not printing correctly (missing
imprint dots).
Cause and Ink is clogged in the ink jet nozzle. Clean the ink jet
Remedy nozzle. Cleaning the ink jet nozzle is recommended
before using the CR-190i. (See "Cleaning the Ink Jet
Nozzles," on p. 49.)
Other The ink cartridge may be empty.
Causes
Condition Documents get dirty when using the imprinter.
Cause and Ink from the imprinter has been placed on the feed path.
Remedy Clean the ink off the feed path. (See "Cleaning the Ink Jet
Nozzles," on p. 49 and "Cleaning the Feed Path," on
p. 43.)
41