Preparation Before Use; Setting Up The Scanner - Canon IMAGEFORMULA CR-190I Instructions Manual

Preparation Before Use

This chapter describes how to prepare the scanner to scan
documents.

Setting Up the Scanner

Perform the following steps to set up the CR-190i. Refer to the section
for each step for details about that step.
Check your operating environment. (See "Checking Your
Operating Environment," on p. 18.)
Install the software. (See "Installing the Software," on
p. 19.)
Install the Scanning Utility provided with the CR-190i.
Connect the scanner to a computer. (See "Connecting
the Scanner to a Computer," on p. 20.)
Turn ON the power. (See "Turning ON the Power," on
p. 21.)
Automatically installing the device driver. (See p. 22.)
The device driver is installed automatically when Windows
recognizes the CR-190i.
IMPORTANT
• To have the device drivers installed automatically when the computer
recognizes the CR-190i, the software needs to be installed before the
CR-190i is connected to the computer.
• If you connect the computer and turn ON the CR-190i before installing the
software, the following wizard screen appears. If this happens, click
[Cancel], turn OFF the CR-190i, and then install the software.
The following wizard screen is an example in Windows Vista. When a
similar wizard screen appears in Windows XP/7, click [Cancel].
Wizard Screen (Windows Vista)
17