Auto Operation - LG LS-J0962HL Owner's Manual

Auto Operation

During Auto Operation:
You cannot switch the indoor fan speed. It has already been set by the Fuzzy rule.
If the system is not operating as desired, manually switch to another mode. The system will not
automatically switch from the cooling mode to the heating mode, or from heating to cooling, it must be
done by manually resetting.
During Auto Operation, pressing the chaos swing button makes the horizontal louvers swing up and
down automatically. If you want to stop auto-swing, press the chaos swing button again.
Press the Start/Stop button.
1
The unit will respond with
a beep.
Open the door on the remote control. To select Auto
2
Operation, press the Operation Mode Selection button.
Each time the button is pressed, the operation mode is
shifted in the direction of the arrow.
Cooling Cooling
The temperature and fan speed are automatically set by the
3
electronic controls based on the actual room temperature. If
you want to change the set temperature, close the door on
the remote control and press the Room Temperature Setting
buttons. The cooler or warmer you feel, the more times (up to
two times) you should press the button. The set temperature
will then be changed automatically.
8
Auto Auto Healthy Healthy
Dehumidification
Dehumidification
To raise the temperature
To lower the temperature
Heating Heating
(Heat pump model only)
(Heat pump model only)