Forced Operation; Auto Restart; Helpful Information - LG LS-J0962HL Owner's Manual

Slide Switch Operation

FORCED OPERATION

Operation procedures when the remote control can't be
used.
Open the front panel upward and move the Slide
Switch to the Forced Operation position.
If you want to stop operation, move the Slide Switch to
the Auto Restart or the Remote Control position.
In case the power comes on again after power failure
on the Forced Operation position, the operating
conditions are automatically set as follows:
During Forced Operation, the initial mode continues.
Cooling Model
Operating mode Cooling
Indoor FAN Speed High
Setting Temperature 22°C

Auto restart

In case the power comes on again after a power
failure, Auto Restarting Operation is the function to
operate procedures automatically to the previous
operating conditions.
If you want to use this operation, Open the front
panel upward and move the slide switch to the
Auto Restart position.
If you do not want to use this operation, move the
Slide Switch to the Remote Control position.

Helpful information

Fan speed and cooling capacity.
The cooling capacity indicated in the specification is the
value when the fan speed is set to high, and the capacity will
be lower at low or medium fan speed.
High fan speed is recommended when you wish to cool the
room quickly.
Room Temp. 24°C 21°C Room Temp. < 24°C
Cooling Healthy Dehumidification
High Healthy Dehumidification Rule
22°C
15
Slide
Switch
Open the front
panel upward
Heat pump Model
23°C
Slide
Switch
Open the front
panel upward
When you are out for a while, put the
Slide Switch on the Remote Control.
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL
Room Temp. < 21°C
Heating
High
24°C
Slide Switch
FORCED
OPERATION
AUTO
RESTART
REMOTE
CONTROL