Philips BFL2114/12 Series Professional Installation Manual page 33

Networks]
[WebServices] [IPUpgradeService] menu
o Select the [Clone RF to TV] menu
o Using this you will be able to clone to the
TV over RF, this happens automatically
when a clone is being played out on RF by
CMND. Via this menu you can manually
force an upgrade to happen
o On the top of the page you will see a
waiting animation while cloning is
ongoing, once finished it will change to
Done
o During the cloning process there will be a
[Cancel] button available, press "OK" to
cancel the cloning process
o Once cloning is complete, [Cancel] will
change to [Close], press "OK" to return
back to TV state
o Navigate to the [Auto Upgrade Settings]
menu
o You will see below items:
o [Auto Upgrade and Clone]: RF upgrade
and Clone upgrade will be enabled
automatically at 4 AM and 1PM if the
TV is in standby and 5 minutes after the
TV is put in STBY if [On] is selected, no
upgrade will happen if [Off] is selected
o [Auto Clone on Wakeup]: Nothing will
happen when [Off] but when [On] the
TV shall search for a new clone when
waking up from standby. You will see a
message
experience" when starting up the TV
Note:
WeatherForecast
SmartInfoBrowser, will be cloned on
wakeup. Depending on SW updates and
feature updates this list might change
overtime
o Navigate to the [RF Upgrade Settings]
menu
o You will see below items:
o [Frequency]: The frequency for CMND
playout can be modified in this menu
Note: Default this should be set to 498
MHz. When an RF upgrade happens,
the TV will first do a scan on the
frequency set here. If nothing is found it
will scan between 44 MHz and 887
- 32 -
[Control TV Over
"Personalizing
TVSettings, ChannelList,
IP]
your
and