Table of Contents
Advertisement
Other Operations In Firing Process
Skip Operation
While a program is in process, press the
program item.
Balance Time
While you press the BAL.TIME button, the remaining time until the end of the Hold time of the final process
appears on the display.
Note) Depending on program contents or numbers of firing ring molds, the balance time on display sometimes
may differ from actual balance time. This is roughly estimated time for the sake of convenience.
Chime Stop
Press the
button if you want to stop M chime or final chime while the chime is sounding.
Program change/confirmation in firing process
1. Press the PROGRAM button during the program operation.
2. Press the
OK/PASS
the stored program, display the item and press the
3. Press the blinking PROGRAM button to release the program confirmation/modification mode.
If no button operation is done in about 4 seconds, the furnace returns to the original
operation display. The changed value will be stored.
Pre-Stored Programs
The following programs are pre-installed on Course No.7, 8 and 9 when shipping. We recommend you to use
the programs with your investment. The values of each program are revisable with your program storage in
program mode.
Course
Investment
L Rise
L Temp.
L Hold
M Rise
M Temp.
M Hold
M Chime
H Rise
H Temp.
H Hold
Finish Chime
OK/PASS
button in sequence to make sure the stored program correct. When you need to change
Christobalite
.
.
－
－
button to skip the program in process and proceed to next
button to change the program.
Simultaneous firing
Phosphate
of christobalite and
phosphate investment
.
.
－
－
-12-
.
.
.
Advertisement
Table of Contents
