Washer - Arrow Storage Products ED86 Owner's Manual & Assembly Instructions

Step 9
W22 ctr
(28)
Each screw in the wall requires a

washer.

CORRECT
1
Slide side siding into channels
of corner posts, flat edge upward,
bottom edge down resting on oor
frame. Always follow this pattern.
Fasten bottom edge and tab of stud
to oor frame using screws. Fasten
center to stud with screws. Do not
fasten at edge yet.
2
Install side siding as before.
Note how the slot in bottom edge
must overlap at edge of last siding.
Fasten both siding panels to stud at
this overlap.
3
Install side siding to the top as
before.
4
From inside building, fasten sid-
ing to corner posts using screws.
5
Repeat steps 1 through 4 for op-
posite side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The oor frame must be square
and level or holes will not align.
(24)
INCORRECT
STEP
4
Parts Needed For
Side Siding
End
View
Bottom
Edge
Flat
Edge
Be certain all Siding
overlaps are fastened
with a single screw
22
8719 Side Siding (6)
STEP
STEP
8719
8719
THIS SCREW MUST
FASTEN TAB OF STUD
STEP
1
3
2
Washer