Canon FAXPHONE L80 Setup Instructions page 5

Install the FX-3 S Cartridge.
1 Lift the latch and open the front cover.
2 Remove the FX-3 S Cartridge from its protective bag.
3 Gently rock the cartridge from side to side a few times to distribute the toner evenly
inside it.
•Print quality may be poor if the toner is unequally distributed.
4 Place and hold the cartridge on a flat, clean surface, then gently pull the plastic tab
straight out to remove the plastic seal.
5 Hold the cartridge by its handle and insert it into the machine as far as it will go,
making sure that its side tabs are aligned with the guides inside the machine.
6 Use both hands to close the front cover.
NOTE
• Do not open the drum
protective shutter on
the cartridge.
NOTE
• Use a firm, even pull to
remove the seal.
NOTE
• Always hold the
cartridge by its handle.
NOTE
• The FX-3 S Cartridge is a starter cartridge
supplied with the machine. The replacement
cartridge is the FX-3 Cartridge separately
available from Canon.
SIDE VIEW
PULL WITHIN
THIS RANGE
TOP VIEW
PULL WITHIN
THIS RANGE