Video Plus - LG LV880 User Manual

GC985/967NP1 NA4ULL-ENG 3/17/04
Recording using VIDEO Plus+
VIDEO Plus+ simplifies the process of recording television programmes. It works by entering codes that contain all the
necessary information for recording. These are called PlusCodes and can be found in most television listings magazines.
You must tune and store channels as set out on page 5 and set the clock to the correct time before using VIDEO Plus+.
VIDEO Plus+ and PlusCode are registered trademarks of Gemstar Development Corporation.
The VIDEO Plus+ system is manufactured under license from Gemstar Development Corporation.

VIDEO Plus+

VIDEO Plus+ will only work if all the
channels have been tuned and
stored. The clock must also be set to
the correct time, see page 11.
1 Turn on your Video Recorder and
your television. Insert a recordable
video tape.
2 Press the VIDEO Plus+ button on
the Remote Control.
VIDEO PLUS+ CODE NO.
- - - - - - - - -
ONCE
0~9, i
3 Use the 3 or 4 buttons to select
the recording type:
ONCE will be a single recording
event.
DAILY will record each week day
at the same time.
WEEKLY will record on the same
channel at the same time each
week.
9:00 AM Page 10
(LV890 Only)
4 Use the numbered buttons to
enter the PlusCode of the
television programme you wish to
record. If you make a mistake
press the 1 button and re-enter
the correct numbers.
5 Press OK and the recording
details of your programme will be
displayed. If PLEASE CHECK is
displayed check that you have
entered the right PlusCode.
If the number has been entered
correctly but does not work, it
may have been printed incorrectly
in the television listings guide.
If '- -' is displayed on the "PR" you
will have to enter the programme
number that you want to record
from. This will only happen once
for each channel, once done it will
be stored in the Video Recorder's
memory. If you wish to record from
the scart socket or RCA socket on
the front press AV.
6 Use the 2 button to move to the
10 Press STOP 9 to end recording.
PDC section. Use 3 or 4 to
switch PDC off or on. If you are
recording from a television station
which does not broadcast PDC
this option should be turned off.
Use the 2 button to move to the
selecting the speed section.
7 Use the 3 or 4 buttons to
choose among Standard Play,
Intelligent Play and Long Play, as
described on page 8.
IP mode determines how much
tape is left and switches speed
To stop a recording you have made
from SP to LP, if necessary, to
being recorded over, break off the
complete recording the
protection tab on the rear of the video
programme.
tape. To record on a tape that has
IP mode is not applicable when
had its protection strip removed,
PDC is on.
cover the hole with adhesive tape.
8 Check the details are correct and
press to save your settings.
Recording tape to tape
If PLEASE CHECK is displayed
You will need a second Video
check that the details are correct.
Recorder for tape to tape copying.
If you wish to set other VIDEO
Connect using a SCART cable from
Plus+ recordings repeat steps 2-7.
the back of your Video Recorder or
Press again to remove the
using the AV sockets on the front.
menu.
Select audio/video mode on the
9 Turn off the Video Recorder,
recording Video Recorder by
TIMER will be illuminated on the
pressing the AV button on the
Display panel.
Remote Control. To monitor the
recording, connect the recording
Video Recorder to your TV using the
standard coaxial aerial cable.
Protect your recordings