Remote Control - VTech SWITCH & GO DINOS Overseer the T-Rex Parents' Manual

REMOTE CONTROL:

1. OFF/VOLUME SWITCH
To turn the Remote Control on and
adjust the volume, slide the Off/Volume
Switch to the Low Volume ( ) position
or the High Volume ( ) position.
To turn the Remote Control off, slide
the Off/Volume Switch to the OFF
( ) position.
2. CONNECTION LIGHT
When the Remote Control is switched
on, the Red Connection Light will
turn on. If Overseer the T-Rex is
switched on, the Red Connection
Light will flash and the Remote
Control will start to connect to
Overseer the T-Rex. If the connection is successful, the Red
Connection Light will turn off and a Green Connection Light
will show once buttons on the Remote Control are pressed. If
the connection fails and the Remote Control cannot connect
to Overseer the T-Rex, please turn the Remote Control and
Overseer the T-Rex off and on again to try again.
Note:
If the Connection Light is off when any of the Remote Control
buttons are pressed, please install a brand new set of batteries
and try switching it off and on again.
521063 IM.indd 9 521063 IM.indd 9
9
03/19/2021 11:54:41 03/19/2021 11:54:41