Advertisement
Quick Links
Loose Parts
Note:
Use the chart below to identify parts used for assembly.
DESCRIPTION
Baffle
Bolt 3/8–16 x 1-1/4" (32 mm)
Locknut 5/16"
Recycler blade
Decal
Installing the Recycler Baffle
1.
Remove mower from traction unit; see traction
unit Operator's Manual for instructions.
2.
Thoroughly clean the mower. All debris must be
removed to ensure baffle fits tightly against
mower.
3.
Repair any dents or damaged areas on the
mower. Replace any missing parts.
4.
Remove the front bolt from each of four (4)
linkage brackets (Fig. 1).
5.
Tip mower upside down and remove standard
blades from spindles.
Model No. 86001
QTY.
1
2
Install under mower
4
3
Replace standard blades on mower
2
Install on sides of mower
1
1. Bolt 3/8–16 x 1-1/4"
(32 mm)
FORM NO. 3319–157 Rev A
INSTALLATION
INSTRUCTIONS
USE
2
Figure 1
2. Lock nut 3/8"
m–2873
1
Advertisement
Related Manuals for Toro 86001
Summary of Contents for Toro 86001
- Page 1 FORM NO. 3319–157 Rev A INSTALLATION Model No. 86001 INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts used for assembly. DESCRIPTION QTY. Baffle Bolt 3/8–16 x 1-1/4” (32 mm) Install under mower Locknut 5/16” Recycler blade Replace standard blades on mower...
- Page 2 Installation Place baffle inside mower location two (2) studs on baffle, into front linkage bracket holes (Fig. 2). Place (2) 3/8 x 1-1/4” (32 mm) carriage bolts through rear linkage bracket holes. Secure carriage bolts and studs with (4) 3/8” locknuts (Fig.
- Page 3 Installation Removing the Recycler Baffle Thoroughly clean the mower. POTENTIAL HAZARD Open holes in the mower expose you and Remove Recycler blades from mower (Fig. 3). others to thrown debris. Remove lock nuts from studs and carriage bolts WHAT CAN HAPPEN (Fig.
- Page 4 Installation Tips for Mowing Grass Ground Speed To improve cut quality, use slower ground speed. Fast Throttle Setting Avoid Cutting Too Low For best mowing and maximum air circulation, operate the engine at “FAST.” Air is required to thoroughly cut grass clippings, so do not set the If the cutting width of the mower is wider than the height-of-cut so low, as to totally surround the mower mower you previously used, raise the cutting height...