Advertisement
Installation
6.
Place baffle inside mower location two (2) studs
on baffle, into front linkage bracket holes
(Fig. 2).
7.
Place (2) 3/8 x 1-1/4" (32 mm) carriage bolts
through rear linkage bracket holes. Secure
carriage bolts and studs with (4) 3/8" locknuts
(Fig. 2).
8.
Tighten all mounting hardware securely.
2
3
Figure 2
1. Stud
2. Bolt 3/8–16 x 1-1/4"
(32 mm)
Install Recycler Blades
1.
Install Recycler blades from kit. Secure with
washer, blade, flat washer, and the blade nut
(Fig. 3).
Note:
Do not install anti-scalp cups as they
interrupt the airflow for Recycling.
IMPORTANT: The curved part of the blade
must be pointing toward the inside of the
mower to assure proper cutting.
2.
Tighten the bland nut to 80-100 ft–lb
(109-136 Nm).
3.
Rotate blades to assure there is at least 1/8"
clearance between blades and baffle.
2
3
m–2874
1
3. Lock nut 3/8"
5
2
1
Figure 3
1. Nut
2. Flat washer – thick
3. Blade
Install Recycler Decal
1.
Remove backing paper and apply decal to both
sides of mower (Fig. 4). Smooth from center to
edges to remove air bubbles.
1 & 2
Figure 4
1. Mower side
2.
Install mower onto traction unit; refer to traction
unit Operator's Manual.
4
3
4. Washer – thin
5. Spindle
1 & 2
M–2829
2. Apply decal
Advertisement
