Advertisement
Assembly Instructions
ALTERNATE HORIZONTAL CONFIGURATION ...
• Shelf can be split into two units and used side by side. Post couplers are not required for this configuration.
• Beams and braces should be positioned in the top and bottom two post holes of each section for stability.
• Follow steps 2, 3 and 7
NOTE: Additional post caps (F) and post feet (G) are not included for this alternate configuration, but may be
purchased by contacting customer service - see contact information below. Order quantity of 4 each of (F)
and (G) and follow steps 1 and 6 when order is received.
STEP 1 ... assemble post feet to post
• Check that each post is in the proper orientation. The post should be
positioned so that the tapered end of the hole is pointing downward.
• Place post foot on the bottom of each for the four lower posts.
STEP 2 ... assemble bottom level
• Assemble one brace to two lower posts skipping one hole from
the bottom of each post. Be sure the longer ledge of brace is on top.
• Place the rivets into the posts, and tap lightly to seat the rivets.
• Repeat this with the other two lower posts and brace.
• Assemble the two beams into the two post and brace assemblies by
placing the rivets into the post. Tap lightly to seat the rivets. Be sure
the longer ledge of the beam on top.
• Place a wire shelf on the ledge of the assembled beams and
braces with the flat side facing upwards.
STEP 3 ... assemble next two levels
• Connect another two braces and two beams to the posts for the next level.
• Check that each beam and brace is spaced equally.
• Place a wire shelf on the ledge of the assembled beams and braces for
each level with the flat side of the wire shelf upwards.
• Repeat for third level.
STEP 4 ... connect posts with couplers
• Position the couplers on the top edge of each bottom post.
• Tap the couplers down to the mid-point of the coupler.
• Position another post into the top half of the coupler and tap down until the
two posts connect fully into the coupler.
STEP 5 ... assemble the remaining three levels
• Connect additional braces and beams to the posts for each level.
• Check that each beam and brace is level and properly spaced.
• Place a wire shelf on the ledge of the assembled beams and braces for
each level with the flat side of the wire shelf upwards.
STEP 6 ... assemble the post caps
• Place and fasten the post caps to the top of each post.
STEP 7 ... final check
• Check each beam and brace connection to be sure that the rivets are
properly seated.
- MR481886W6B
Post
Brace
Brace and Beam longer
ledge must be on top.
Post slot
tapered ends
points down
Beam/Brace
Rivets
Inside view
E
A
F
Alternate horizontal
configuration
A
G
Tap lightly
Beam
Wire Shelf
A
E
Advertisement
