Advertisement
Setting or Changing Security for Your 5.0GHz Wireless Service
To set or change the security for your 5.0GHz Wireless Service, complete the following steps
1. With
Figure 4
on page 5 displayed, select 5.0GHz and then Security;
2. WPS should be Enabled (set as Factory Default). If it is not, in the window adjacent to Enable WPS, select the check mark so
Enable is displayed.
3. If you want to change the Network Authentication type for 5.0GHz, select a new value from the drop-down list.
4. In the window adjacent to WPA/WAPI passphrase, enter a password that will be used for this wireless service.
Apply/Save.
5. Select
Logout
61287781F1-13A
Select SSID
Network Authentication
WPA/WAPI passphrase
Figure 6. Wireless 5.0GHz - Security
Figure 6
will be displayed.
7
Advertisement
