Husky HPRO72HUTCHBLK Use And Care Manual page 8

3
Attach the LED light
□
The LED light has been pre-installed on the shelf. Remove any packing materials and the nylon cable ties
bundled at both ends of the LED light.
□
Insert the power cable into the end of the LED xture, and reposition so it's centered on the shelf.
Note: The back of the LED xture is magnetic and attaches directly to the articulating holder under the shelf.
□
The LED is equipped with a dimmer function built into the power switch.
□ Touch the power switch button once for 100% output. Touch again for 50%, again for 20%, and again for OFF.
□
The Motion Sensor (II) is magnetic and can be installed where best suited according to your preference.
□
It is equipped with an On/Off button and the LED can work with or without the Motion sensor. Once motion is
detected, the LED stays on for approximately 150 seconds and will turn off if no motion is further detected.
□
The dimmer setting (100%, 50% or 20%) is saved each time the Motion sensor turns the LED on and off.
□
Plug the transformer cable into the motion sensor and route the cable through the access grommet to a power
source.
Nylon cable
Magnet
II
8
Magnet