1. Names of components
Precautions before measurement
After replacing the batteries or changing the location or environment of the unit, it takes time before
accurate readings are displayed due to the sensor built into the unit.
After replacing the batteries, it takes about one hour for accurate values to be displayed, which is the time
required for the sensor to detect and adapt to the new environment (only when installed for the first time).
■ First, remove the protection film from the LCD.
Remove the battery lid and install the batteries by following "Replacing the batteries".
Front View
①
②
③
④
⑤
⑥
①
Temperature (°C)
②
Humidity (%)
③
Low battery icon: Lights up when the battery is low. Immediately replace with new batteries.
④
Heatstroke indicator: Caution and warning are displayed in five levels, under the current
⑤
Lights up when the alarm is turned on.(In the clock display mode)
⑥
Lights up when the WBGT warning sound is turned on.(In the WBGT display mode)
⑦
LCD protection film
⑧
Seasonal influenza index indicator:
Caution and warning are displayed in three levels, under the current temperature and humidity
conditions.
⑨
Clock display (12/24 hour time format), WBGT value (°C) display, Absolute humidity (g/m
* Press the MODE button to switch between the modes.
⑩
Hook hole (Wall-mounting hole)
⑪
Air vents: Do not use the air vents as wall-mounting holes. Doing so is dangerous and could cause
the unit to fall, resulting in injury.
⑫
Battery lid: two AAA batteries are used
⑬
Stand
⑦
⑨
⑧
temperature and humidity conditions.
Rear View
Reset button
2
⑩
⑪
⑫
⑬
3
) display