Periodic Replacement Of Parts - Hitachi ZAXIS 17U-2 Operator's Manual

PERIODIC REPLACEMENT OF PARTS

To ensure safe and long trouble free operation, be sure to
conduct periodic inspections of the machine. In addition,
the parts as listed below are directly related to safety op-
eration so that they are recommended to be periodically
replaced. These part material properties will change due to
aging, or repeated operation may cause deterioration, wear,
and/or fatigue of these parts, possibly resulting in serious
safety/fire hazards. It is very difficult to gauge the remaining
service lifetime of these parts simply by visual inspection
alone. For this reason, replace these parts at the intervals
shown in the table below. If any of these parts are found to
be defective by inspection, immediately replace it regard-
less of the recommended intervals.
Consult your nearest Hitachi dealer for correct replace-
ment.
Engine
Base Machine
Hydraulic
System
Front Attachment
NOTE: When replacing a hose, be sure to replace seals, such as O-rings and gaskets, along with the hose.
MAINTENANCE
Periodic Replacement Parts
Fuel hose (Fuel tank to filter)
Fuel hose (Fuel tank to injection pump)
Engine rubber vibration insulator
Pump coupling
Pump suction hose
Pump delivery hose
Swing hose
Auxiliary hose
Oil cooler hose (C/V to oil cooler)
Boom cylinder line hose
Arm cylinder line hose
Bucket cylinder line hose
Pilot hose
Seat Belt
7-6
Replacement Interval
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 5 years or 3000 hours
Every 5 years or 3000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 2 years or 4000 hours
Every 3 years