Table of Contents
Advertisement
CLEANING THE INLET HOSE AND THE VALVE FILTER
1
1
2
3
FROST PRECAUTIONS
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the drain
pump.
Do this procedure also when you want
to do the emergency drain.
1. Disconnect the mains plug from the mains
socket.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear support
and unhook it from sink or spigot.
4. Put the ends of the drain and inlet hose in a
container. Let the water flow out of the hoses.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
INTRODUCTION
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with water
properly. Start the appliance again by pressing
button. After 10 seconds the lid will be
unlocked.
2
3
5. Set any selected programme with option
and let it operate until the end of the cycle.
6. When no more water flows, install the inlet
hose and the drain hose again.
7. Press the
button to deactivate the
appliance.
WARNING! Make sure that the
temperature is more than 0°C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
•
- The appliance does not drain the water.
•
- The appliance lid is open or not closed
correctly. Please check the lid!
•
- The mains supply is unstable. Wait until
the mains supply is stable.
•
- No communication between electronic
elements of the appliance. Switch off and
switch on again. The programme was not
finished properly or the appliance stopped too
early. If the alarm code appears again, contact
the Authorised Service Centre.
WARNING! Deactivate the appliance
before you do the checks.
4
90˚
15
Advertisement
Table of Contents
