Advertisement
Technical Bulletin
1.
Turn the sensors vertical height adjustment screw clockwise; lowering it to within
1/8 inch (1/4 cm) of the paper.
2.
Select the media size (see page 6 - 3 of your Guide to Operations).
From the keypad main menu:
3.
Press (F3) "Action"
4.
Press (F2) "Tests"
5.
Press (F4) "SensTst"
6.
Press (F1) "Mark"
7.
The plotter should then draw a one-inch mark, at the paper edge.
8.
Press (F4) "Scan"
9.
Turn the adjustment screw counterclockwise until the beep sounds each time the
mark passes under the sensor.
10.
Start counting turns of the screw, and continue raising the sensor until the beep
is not heard any more.
11.
Note the number of turns counted, divide that number by two, and turn the
screw clockwise that many turns.
12.
The sensor should now be in the middle of the focal range.
Frame Sensor Adjustment/
Stylist 2000 & LP 7200
Advertisement
